2.1.2.1 LEAD-ACID BATTERY ELECTROLYTE UN 2796 Applies to: Electrolyte of lead-acid batteries UN No., Proper Shipping Name UN 2796, BATTERY FLUID, ACID Class 8 Packing Group II Hazard Label • Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced on small packages. • They must have a line 5 mm inside the edge and running parallel with it. General Requirements • metal packagings must be corrosion resistant or with protection against corrosion • aluminum construction materials cannot be in contact with the battery fluid. Transport mode Road Marine Air Passenger Aircraft Cargo Packing instructions 173.202 P001 PI 851 PI 855 Inner: Non approved inner packagings made of Glass, Plastic, or Metal Outer:Approved outer packagings meeting the Packing Group II performance standard, of the type: Drums (1A1, 1A2, 1B1, 1B2, 1N1, 1N2, 1H1, 1H2, 1D, 1G) Jerricans (3A1, 3A2, 3B1. 3B2, 3H1,3H2) Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2, 4N) Combination Packagings Inner: Non approved inner packagings made of: Glass - maximum capacity 10 l Plastic - maximum capacity 30 l Metal - maximum capacity 40 l Outer:Approved outer packagings meeting the Packing Group II performance standard, of the type: Drums (1A1, 1A2, 1B1, 1B2, 1N1, 1N2, 1H1, 1H2, 1D, 1G) maximum net mass 400 kg Jerricans (3A1, 3A2, 3B1. 3B2, 3H1,3H2) maximum net mass 120 kg Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2, 4N) maximum net mass 400 kg Combination Packagings Inner: Non approved inner packagings made of: Glass - Plastic - Metal Net quantity per inner packaging: 1 litre 2.5 litre Outer: Approved outer packagings meeting the Packing Group II performance standard, of the type: Drums (1A1, 1A2, 1B1, 1B2, 1N1, 1N2, 1H1, 1H2, 1D, 1G) Jerricans (3A1, 3A2, 3B1. 3B2, 3H1,3H2). Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2, 4N) Total net quantity per package: 1 litre 30 litres Single packagings Drums: (1A1, 1A2, 1N1, 1N2,1H1, 1H2) Jerricans : (3A1, 3A2, 3B1. 3B2, 3H1,3H2) Single packagings Drums Maximum capacity 450 l (1A1,, 1B1, 1N1, 1H1) Maximum capacity 250 l) (1A2, 1B2, 1N2, 1H2) Jerricans (Maximum capacity 60 l) (3A1, 3A2, 3B1. 3B2, 3H1,3H2) Single packagings not permitted Single packagings Approved outer packagings meeting the Packing Group II performance standard: Drums (1A1, 1B1, 1N1, 1H1) Jerricans (3A1, 3B1. 3H1) Total net quantity per package 30 litres IBC – Intermediate Bulk Container The following approved IBCs are authorized, (1) Metal (31A, 31B and 31N); (2) Rigid plastics (31H1 and 31H2); (3) Composite (31HZ1). IBC not permitted IBC shall be fitted with two shut-off devices. Weight limit see packaging limits see packaging limits see packaging limits see packaging limits Marking and Labelling of Packages UN 2796, BATTERY FLUID, ACID UN 2796, BATTERY FLUID, ACID UN 2796 BATTERY FLUID, ACID Full Name ad Address of the shipper and the consignee Net Quantity (l) The words “THIS SIDE UP” or “THIS END UP” may also be displayed on the top of the package. Minimum dimensions: 74 × 105 mm Minimum dimensions 74x105 mm 120×110 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document Transport document Shipper’s Declaration 52 Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==